Current filter:
                                You should refresh the page.
                                0
                                Bob Perkins 07.19.2012

                                  • I've been using the TxcDBMaskEdit with a mask of ##:## to accept times. Data entered into the field is seen at entry time and gets stored properly in the DB. When I pull the record back up the control shows blanks. The data is there, I added a TcxDBEdit control to display the same field and 10:00 is displayed in this field.


                                    Don't know what I'm doing wrong because up until I upgraded the control was working fine. Can some one tell me what I'm doing wrong?


                                    Thank you.

                                • Paulo (DevExpress Support) 07.20.2012

                                  Hello,

                                  Would you please provide us with a small sample project to demonstrate the issue? It may help us precisely replicate your scenario on our side.

                                  In addition please specify the version of our controls where this approach worked correctly.

                                Leave a Comment
                                You must  log in  or  register  to leave comments
                                You must  log in  or  register  to leave an answer

                                Is your intention to post an answer to your own question?

                                • If so, then proceed.
                                • If you simply wanted to post additional information, ask for further clarification, or to just say "Thanks!", please click Leave a Comment.
                                • If you wish to edit your original question, please use the Edit button in the Toolbox at the top right corner of that entry.